Tried to make the Simple Project. Followed the instructions and do not get the Cuts/Layer box.
Closed the program and retried same rosulates.
Can you take a full screenshot of LightBurn?
Here is a guide on how to set up a Sculpfun laser using LightBurn: Setting up the software - Diode Laser Wiki Maybe that helps.
Can I uninstall lightburn then reinstall it without losing my license key ? I tried to restore and that did not work
Yes, that’s absolutely no problem. Your license key can even be used on two different PCs. A re-install does not invalidate the license.
Thank you Melvin for the quick response. I will let you know if it resolves my problem.