No Laser light using frame

[jchan1950 (Jerry)]

I just updated to latest Lightburn. I have the laser light in the move section with the fire button, but when I go to the frame, the laser does not fire so I can see the frame.
This worked fine before I updated. Any suggestions would be highly appreciated.
Thank You
Jerry

[Bertus (oud)]

press fire button,than Shift+ frame

[LightBurn (Oz)]

How do I turn on my diode at low power to focus it or frame a job?

Diode lasers often don’t have a red-dot pointer like CO2 lasers do, so it is often useful to enable them at low power for focusing or framing. (Please do NOT do this if you have a CO2 laser, as the beam is invisible and this could blind you or start a fire) In LightBurn, go to Edit > Device Settings, or click here: [image] Turn on the ‘Enable Laser Fire Button’ switch (make it green): [image] Quit LightBurn and re-run it. You will now have two new controls in the Move window. A …

[jchan1950 (Jerry)]

Thanks a lot, old guy here had a senior moment, I forgot the shift key
Thanks again