ho installato lightburn 1.7.0.1 pero’ quando accendo il laser sculpfun s 9 da 22 watt non lo vede ,praticamente non si accende ,spero che possiate aiutarmi grazie
The Sculpfun S9 has 5W, not 22W. Just for information.
Did you install the USB drivers? Here is a guide: Setting up the software - Diode Laser Wiki
si hai ragione pero’ ho preso il kit da 22 watt e lo montato
Ok, that’s a different thing then. Show a picture of the mainboard, how you mounted everything. The new mainboard has an emergency switch port, that port must be bridged, otherwise it won’t turn on.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.