Not corect cutting

LightBurn Software Questions
9

In that case, please do the following:

  1. Use the .dxf file (Calibrate Axis File.DXF (43.2 KB)) to cut on the the material of your choice. Ensure that the model is placed such that X on the model is aligning with X axis of the machine.

  2. Measure the X and Y lengths

  3. Edit - Machine Settings - Calibrate Axis
    Calibration Axis - X
    Requested Distance - 25
    Actual Distance - ________ ( Measured X length, just number will do no need of adding units)
    Click Write

Calibration Axis - Y
Requested Distance - 25
Actual Distance - ________ ( Measured Y length, just number will do no need of adding units)
Click Write

  1. Try cutting the same file once again and check the measurements,

    If it still needs fine adjustments repeat steps 1, 2 and 3.

                                         OR

    if it is perfect, try cutting a different geometry to check your results.

1 Like