Does your job include Z movement? Also, which version were you using when this happened (before you reverted to an earlier version)? You said latest version. Did you mean 1.0.04?
There was an issue with Z moves during a job that was looked into in March. (this is why I asked about if you had any Z moves).
Do you have a 6442 or 6445 Ruida? Which firmware version are you running on your controller? I have a 6445 Ruida. Is this file one that you would not mind posting on this message (or sending to me personally)? If so, I can test it on my machine to see if I have the same outcome.