Not getting clean glass engravings

I have tried changing speeds and power settings and all I get is rough and unacceptable images. I use the chuck rotary with a 100w Omtech with the Lightburn software . what is the trick to create clean images on glass. I would like any assistance i can get. oh and try to explain it in terms i will understand and where to go to make changes. If this is the best it gets engraving glass then all i have to say is IT SUCKS ! Sorry about the harshness but im very unsatisfied. thank you

Can we see your results? Photo?

What type of rotary do you use?

:smile_cat:

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.