Nvum v2 Controller?

[jkwilborn (Jack Wilborn)]

@Oraibi

controller NVUM v2

It’s a Mach3 based controller…

Use Lightburn for CNC Controllers (Mach3, Mach4, simCNC ...)

I built a CanCam device profile and looked at S in Device settings. S=1 for CanCam, so I can see that your reasoning is that Smax is 1 for on and 0 for off. Other grbl flavors use Smax=255 or Smax=1000 and LightBurn gladly manages the variable laser/spindle power requests. Please create a plain GRBL device profile for use on your project and your laser equipped mill. Please report back with troubleshooting questions if it’s not working.

Then follow @Dskall advise about the trial version.

You can find other threads on the Mach3 board, by searching the site for Mach3…