This is one of the first tests. We set everthing up and ran a simple line test and some other tests to get machine setup and power set for controller. This test came out so far off we stopped. The boxes are supposed to be a typical grid but are all over and stretched. I spent a while looking around for a setting or something that may be off. This may be an issue with the laser and not just a simple setting. I am emailing OMTech as well.
This is very likely the Ruida PWM Skewed Engraving issue. See here:
Configuring a Ruida - LightBurn Software Documentation
2 Likes
That was the issue. Thanks for saving me more hours looking.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.