Omtech B10 not recognized by Lightburn

[MikeyH (Mike Hembrey)]

Error:42 is before Alarm 6.
Maybe this, starting at posting #17, can answer some questions…

Error: 42 side laser randomly stops mid burn

I’ve seen this sort of issue stem from an under-rated power supply on devices that use a relay to control air assist on/off. My Sculpfun S30 alpha unit had a board that reset when you turned on air assist, because it was drawing too much current from the anemic power supply. Sculpfun was quick to rectify with a new board and power supply. Perhaps you have another power supply on hand with the same plug polarity and more current capacity to test with?