Not sure why I’m getting this. I just put it together and turned it on. It homed fine and I was getting ready to burn a grid I keep getting this message. I have reset it by right clicking device. I turned it off and unplugged it and turned it back on and am still get this code.
If you search the forum you’’ find a lot of error code 9 for Ortur. It appears to be a short.
Unlikely Specially with that console error
User needs to scroll up on console and verify what triggered Error 9
Error 9 = Alarm state
This alarm state is caused by something else, odds are Alarm 2 by that console
Once in alarm state it needs to be power cycled or Right click Device button to reset
1 Like
Here is what I get before that error 9. ALARM:2
G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)
On or near line 5:
Job halted
Stream completed in 0:00
[MSG:Reset to continue]
ok
That makes more sense with all the info, what do you have your engraving speed set at and what units are you using ?for this project?
Agreed , I have deleted my other comment to avoid confusion .
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.