Ortur LU3-20A framing problem

Community Laser Talk
1

I have a Ortur LU3-20A laser and although I know this isn’t really a Lightburn problem I have no where else to turn as Ortur support seems to be nonexistent.
When framing I could barely see the laser on the project so I turned it up from.05 to 1.0 but still can’t see it through the amber shield onthe laser head,

image
image665×883 56.4 KB

Is there any way to temporarily remove the amber shield while framing? If not,any suggestions as to remedy yhis problem would be deeply appreciated.
Thanks,Tom

2

Not really no
Suggetion
Absolute coordenate always
Raise the module and frame with 5% (you will be out of focus)
Once you set your material in the right place, refocus it (lowering)

done
cumbersom but best and safest way

1 Like
3

Thank you as always!

1 Like