Since the new software update my lightburn camera will not function as it did before. I have recalibrated it several times and the updated overlay is extremely large. Also after calibration the laser position is off from the position that I have selected.
Try rerunning alignment. Camera may have defaulted to a different resolution forcing you to have to recalibrate and realign.
Continue to run alignment until it works?
Sorry. You had mentioned recalibration. I didn’t realize you had lumped in alignment with that.
Somehow it seems that the alignment isn’t being applied properly…
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.