This is a longshot, but since nobody else has jumped in, I had a display problem after the routine and couldn’t figure out the issue. I finally closed the program completely and restarted. Things were OK after the restart.
If you aren’t that lucky, I bet it will probably help Oz troubleshoot things faster for you if you confirm -
- Can you see those missing sections now with the uncorrected small view in the camera tab?
- Did you do all 9 captures of the calibration target in the correct order (or did you just do 4)?
- What were the approximate scores for the lower left and lower right captures (where you seem to be having image problems now)?
- What the lens view/camera angle of the camera you are using, how big is the bed and how high is the camera above the bed when the lid is open?