Question if i may
Any particular reason for when an image is imported and pass-through is applied the only avaialble angles of engraving are 0 - 90 - 180º?
attempting to add a different angle revertse to those.
Been asked not sure what could be the limitations
Pass through means “no resampling allowed”. It’s not possible to scan an image off-angle without resampling it (well, not easily at least) because we rotate the image and scan it horizontally, then just rotate the cutting path back again.
Got it! Many Thanks!
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.