Is there any possibility in future versions(or workarounds in the current) that an ability to enter a time delay between engraving and cutting so that if engraving out of focus, allows time to adjust the z axis.
Various approaches are possible. You could cut selected graphics and use absolute coordinates (select engraving; run job; adjust z; select cut; run job).
You could apply a start delay to your cut layer of the number of seconds you want before starting. If you max that number out, you could create a buffer layer at 0% power, crawling speed, and on a line segment length just for this purpose of the delay.
On your particular machine, do you manually adjust Z? Is Z not motorized and tied into your controller?
It’s possible to create a layer that has Start / End delays per cut, but it’s not possible to set a delay for an entire layer.
Something that’s relatively easy, if you have a spare layer: Draw a line using a spare layer, set it to 1% power, and 1mm/sec speed. Draw the line however long you want the delay to be (10mm at 1mm/sec is 10 seconds). 1% power isn’t going to fire the tube, and your machine has a pause button, so the delay really only has to be long enough to give you time to hit the pause button, then un-pause when you’ve made the adjustment.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.