Possible lens issue on my diode OLM3?

[ednisley]

@BomUser

Sometimes I wonder if it’s mechanical

Most likely, it is.

This thread covers pretty much the same problem and should help pin down the solution:

Unintentional Offset when using sublayer

Hey all! I have had an issue I have not encountered before when running sublayers, one for fill and one for trace. As seen in the pics, the trace somehow offset but only above the fill. The offset doesnt show up in the preview. Im reasonably certain it isnt that my material moved because the flourish before the name I have on a third layer but is also set with a sublayer for a trace and ut did the same offset. Any idea what I have done and how I can fix it? Thanks in advance [1116242205a…