When I hit “Start” to send my project from Lightburn to my laser a small screen pops up that shows the upload percentage. I assume we all see this. Once in awhile my upload does not complete. This would not be an issue except the laser starts to do its thing before the project is at 100%. Typically it is not an issue as I hit stop and restart it. However sometimes when engraving cups the start point does not line up perfectly so you can see an double line.
Is there a way force the laser to wait until the upload hits 100% before starting? my laser is a 50W Omtech with a Ruida controller. Thanks!
Use send and start it from the machines console…?
Thank you Jack.
So simple…Obviously I am new to lightburn 
I appreciate you.
Don’t worry, you’ll get over it 
If you have a question, ask… we don’t learn this stuff by osmosis…
2 Likes