Power Scale not adjusting

I have a Frankenstein K40 with the original power supply and a Cohesion3D board. In Lightburn, when I set the power scale I don’t get a change in power. I have my max and min % set correctly for my tube and my potentiometer is set to the max output of 10mA. When I change my max power of the layer it acts correctly. If I set the max for the layer to 100% and set the power scale of an shape, say to 10%, I get the max current set on the layer not the power scale of the shape. Any ideas what I’m doing wrong? I also changed the PWM in the config file to 400 from 200 with no change.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.