Print and Cut - one or more of your shapes are crossing the edge of the machine workspace

[JessN (Jess)]

Thanks for humoring me and providing your settings.

I wonder if you should try disabling your pointer offset as mentioned in this forum post?

New Issue with "one or more shapes are crossing the edge of the machine workspace" error

Are you certain that’s the shape causing an issue? Do you possibly have shapes not visible that are being considered as part of the job? Another possibility is if you’re using the crosshairs that shapes that are too far left may be considered out of bounds. If that’s the case then you could temporarily disable the pointer offset and burn without the offset enabled. If none of these work or make sense can you upload the .lbrn here for review?