Print and Cut using a USB flash drive

LightBurn Software Questions
1

Hello,

I have a Jtech laser that attaches to my Onefinity CNC. I need to engrave some baseboard trim that is about 8ft long and only have a 4ft cnc bed Trying to figure out the best way to use the print and cut feature with this. To transfer files I use a USB flash drive. Is it possible to use the print and cut feature with a USB flash drive and if so how? Have been searching for a possible video on this and various forums with no luck yet. Thank you

2

I don’t think it’s possible to use Print and Cut with a flash drive. Specifically because it requires positioning of the laser head to targets and setting those targets in Lightburn. If the laser isn’t directly connected to Lightburn, there is no way to set the targets.

1 Like