Problem with Camera alignment

I have not used my Emblaser 2 for 9 months due to serious illness.

I started again tonight and thought I better calibrate the lens. Wasn’t too successful and used preset 120/fisheye which gives quite a square image of the material.

I have a problem. If I put engraving material say in the NW quadrant of the mat. The engraving takes place in the SE quadrant exactly opposite where it should be. The engraving is always directly opposite where it should be.

The view is from the camera to the front of the machine

Could you please offer advice?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.