Problem with Co2 laser

Greetings! I have the following problem. I purchased a Co2 laser with Ruida panel. When I go to engrave something the laser head moves much more than necessary. If I engrave a 50 mm long writing the laser moves for 120/130 mm but the engraving is of the right size. Which parameter should I change to make the laser head move only for the length of the incision and not beyond? Thank you all

Please don’t double post. It makes it more difficult for us to assist…

This has been had posts here…

:smile_cat:

1 Like

you were very kind. thank you very much

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.