LightBurn Software Forum

Problem with random horizontal lines on my engraving

LightBurn Software Questions Licensing

grbl, ortur, ortur-laser-master-2, troubleshooting

parsec (FerAS) June 21, 2024, 10:50pm 2

I believe you need a firmware update.

ORTUR LASER MASTER 2 PRO S1 & S2 Firmware update Ortur Lasers

Current Advisories : 15-Dec-21 - Status Final - Strongly Recommended Firmware Update Ortur Laser Master 2 Pro S1 - 1.75 Firmware Update Ortur Laser Master 2 Pro S2 - 1.87 Firmware Update https://ortur.tech/latest-firmware/#olm2pros2 Ortur Laser Master 2 Pro 1.5 Series update should be dropping next days too. OLM2 1.4 series will also recieve a firmware update, its ready we just trying to pace ourselfs. 1.42 will launch with only 2 small housekeeping changes. Few important aspects in the …

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled