Hello, I just acquired the Falcon 2 Pro 22W laser engraver and I hope to find an answer on my problem of calibration of my camera with Lightburn 1.7.03
The camera is recognised by software but when I launch the alignment wizard of the camera, I arrive at the step where I have to click and define the 4 corners of the test printing and the display defect Not allowing to finalise the calibration.
Here are the screenshots that show you the defect.
I would like to buy the license because I think Lightburn is very interesting, but with this problem that I cannot use Lightburn
Thank you very much for your help.
Alain
