Hello. I’m having trouble updating the LightBurn software. With updated versions 0.9.21 and 0.9.22 mi, the laser image is engraved twice - the image is shifted (shown in the photo below). With version 0.9.20, it engraves images without any problems. For all versions 0.9.20, 0.9.21 and 0.9.22 I have exactly the same settings set.
Thank you, Tomaž
Your profile says, “K40”, but we are going to need more information that this. Which controller and firmware?
Hello. I use the following control panel: Cohesion 3D.
Thank you, Tomaž
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.