Rabbit Laser Machine 60W Model HX6090-60E + Cloudray Ruida Controller (RDC6442S-B (EC)

LightBurn Hardware Compatibility Ruida controllers
, , , , ,
1

HELP! I have the following:

Rabbit Laser Machine
Model HX6090-60E
60W
Cloudray Ruida Controller RDC6442S-B (EC)

Do you have a standard or recommended machine settings for a 60W Laser Engraver?

or

Do you have a standard or recommended machine settings Cloudray Ruida Controller (RDC6442S-B (EC)?

I am wondering if there is a document somewhere with a general guide or recommended baseline machine settings for a 60W? Like what are the standard or recommended X / Y acceleration speeds for 60W? Thank you in advance for your time and support!

NOTE: My machine does not have a manual or any recommended settings. Additionally, I couldn’t find any recommended settings for the Ruida controller.

NOTE: I recently installed the Cloudray Ruida Controller (RDC6442S-B (EC)

2

These are a settings file from my machine back in 2021. It’s about the best I can suggest.

blue-laser-machine-settings.lbset (12.7 KB)

Should get you going. Make sure you save any values you’ve put in as loading a new file will wipe out most of the vendor settings and apply these.

Mines an OMTech China Blue 50W machine using a Ruida 6442g controller.

Photo, near when I got it and it’s current state.

original-current-20220614
original-current-202206142991×1005 556 KB

If you have issues, sing out.

:smiley_cat: