Raycus 30w Fiber Laser backwards marking

I have a Raycus 30w fiber laser that when I run it marks everything backwards from what is programmed in Lightburn. I have read many threads in this forum about similar problems and they have to do with changing the origin located in the Device Settings area. However, in my particular set up there is not a place where this can be done. Is there a different location to change this or some other setting that needs to be corrected?

Thank you in advance!

If it’s backwards in the X dimension, try enabling ‘Reverse Direction (Negate)’ on Galvo 1 in your Device Settings.

1 Like

Perfect! Thank you!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.