When setting up for a vector cut, the layer settings don’t let me set the speed greater than 300in/min. I should be able to set the speed to 9921in/min which is 100% speed.

Small Update @DanLand Dev team found the issue and should be patched for the next RC Build. Thank you again

Hello Dan The Specifications on the Epilog Fusion Pro are 4200mm/sec or 165 in/sec So the 9921in/min should be possible on the UI, Inquiring internally.

Hello Dan There seems to be for sure something going on between the cut/layer Panel Speed (in/min) and the internal Cut/Layers Editor Input. Thank you for bringing this up. Investigating

RC7, Epilog Fusion Pro48

LightBurn Software Questions

DanLand (Dan Landrum) October 16, 2026, 12:30pm 5

Sounds good, thank you.

RC8, Epilog, macOS