Re aligning job after accidentally shutting down rotary job

I just bought a creality rotary kit for my Falcon 2 22 watt laser. I had problems with it crashing into the right side but thanks to your previous posts, I fixed that. I was engraving a good water bottle of my wife’s and it was engraving perfectly. I reached into the engraver and bumped the emergency kill switch half way through the engraving. How do I get it to perfectly align to start where it left off?
I just downloaded 1.7.01. I love new trim function. Thanks for adding that.

Jim

I do not know the posting, but someone said to start the burn at the top (image wise) and burn until it meets the original. Hopefully, you did not move the rotary base and lose alignment.

1 Like

My guess is it would just call current position the new zero. Might be worth a try though with power really low.

Here it is. Set the scan angle to 180 degrees.
Google: [how to restart a partially completed lightburn job]
(how to restart a partially completed lightburn job - Google Search)

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.