I don’t know if this was a side effect of fixing the problem with back-to-back Z axis moves in 0.9.20 but…I have Relative Z Moves Only set as well as the other 2 Z axis settings. Now with 0.9.24 it no longer honors the Relative part of this. When I have back-to-back Z moves it appears to go back to home before moving the bed. So if the file starts at 0, has a Z move down -1, then the next layer is down -2, it comes back up before moving the bed down. I would have to go back to 0.9.22 to see if it was in there as well. Any idea why it’s not honoring the Relative moves only?