Remove overlapping lines when using offset

Hello everyone,
I’m trying to use the 'remove overlapping lines, those are 2 mirror part together.

The function work as it only need to do one cut in thew middle, however, the offset is incorrect for the part that is being cut whitouht the center lines, my pârts doesn’t fit well. Is there a way to solve this?

You can adjust the kerf offset to account for parts size deviation. You’ll have to already know the kerf of the cut for your laser and material.

Information about kerf here:
Line Settings - LightBurn Software Documentation

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.