Rescale the power %

Hi i have a home built laser using a ruida RDC6442G controller, a generic 50w tube and a MYJG-50W power supply.

I have added an amp meter and the max amps for the tube is about 75% in lightburn, i have set this limit inside the ruida to prevent damage to the tube but i would really like to rescale the lightburn power percentage so i can get to 0-100% instead of 0-75%. i don’t see a pot that is labeled to tweak this on my power supply.

is this possible?


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.