Rotary Settings not in Laser Tools

[berainlb (PY)]

I think the situation is that Rotary is not supported for Trocen-AWC lasers.

Check this old post on the matter:

Rotary for Trocen?

That’s effectively what’s done for some machines, but the problem then is that the system has no way to properly respect travel speeds. What might be a valid linear speed for the Y axis when not connected to a rotary could exceed the limits of a rotary, or the opposite could be true and the controller could limit the rotational rate, thinking that the axis was traveling too fast - it affects how the controller ramps power, takes corners, and so on. So, yes it can be done, and it’s probably fine…