I’m a bit hesitant to burn scratch paper. Pretty sure my enclosure will not start on fire, but I might seriously damage my diode module. I am using the sculpfun s10, although I have never noticed a real diff from the s9. It’s supposedly a 10w as opposed to a 5.5. I want to run at 1200-1300 mm/m and I’m thinking 7% max power? These sheets are kinda cheap…but not as cheap as tile. I don’t want to go through100 of these just to get good results
.
Any suggestions would be greatly appreciated. I am also just thinking jarvis for dithering I don’t think grayscale would matter. I’ll post what I can do. Hopefully will be here with my magnets tomorrow.