Good morning everyone! I have had an S9 for 11 months and it has never given me any problems. Suddenly this morning in the framing phase the laser head went crazy going here and there without control … in the LightBurn gbrl console it says:
[in red] error: 7 Eprom read failed. Reset and restore defaults and it is written:
[in black]
$ 0 = 10
$ 1 = 25
$ 2 = 0
$ 3 = 0
$ 4 = 0
$ 5 = 0
$ 6 = 0
$ 10 = 1
$ 11 = 0.010
$ 12 = 0.002
$ 13 = 0
$ 20 = 0
$ 21 = 0
$ 22 = 0
$ 23 = 0
$ 24 = 25,000
$ 25 = 500,000
$ 26 = 250
$ 27 = 1,000
$ 30 = 1000
$ 31 = 0
$ 32 = 1
$ 100 = 80,000
$ 101 = 80,000
$ 102 = 250,000
$ 110 = 6,000,000
$ 111 = 6,000,000
$ 112 = 1000,000
$ 120 = 1000,000
$ 121 = 1000,000
$ 122 = 10,000
$ 130 = 410,000
$ 131 = 400,000
$ 132 = 200,000
I would like to do a test that is to manually set the parameters of the S9 that normally LB would read from the EPROM.
Would anyone be kind enough to post me the initial parameters that are read from the console card as soon as lightburn connects to the S9?
Thank you and good day
FYI, I have homing switches installed
$0=10
$1=25
$2=0
$3=0
$4=0
$5=0
$6=0
$10=0
$11=0.010
$12=0.002
$13=0
$20=1
$21=1
$22=1
$23=3
$24=200.000
$25=3000.000
$26=250
$27=3.000
$30=1000
$31=0
$32=1
$100=80.000
$101=80.000
$102=250.000
$110=6000.000
$111=6000.000
$112=1000.000
$120=500.000
$121=500.000
$122=1000.000
$130=410.000
$131=400.000
$132=200.000
ok
that were the factory default settings of my sculpfun s9 that i bought some weks ago when i first switched on:
$0=10
$1=25
$2=0
$3=0
$4=0
$5=0
$6=0
$10=1
$11=0.010
$12=0.002
$13=0
$20=0
$21=0
$22=0
$23=3
$24=200.000
$25=3000.000
$26=250
$27=3.000
$30=1000
$31=0
$32=1
$100=80.000
$101=80.000
$102=250.000
$110=6000.000
$111=6000.000
$112=1000.000
$120=1000.000
$121=1000.000
$122=1000.000
$130=410.000
$131=400.000
$132=200.000
Just as additional information: here is a documentation of all settings: Firmware Update & Settings - Diode Laser Wiki
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.