Set point of origin for fiber laser?

LightBurn Hardware Compatibility Galvo
1

I came from EZCAD and EZCAD set point of origin into middle of workspace.
At LB I have a workspace of x=180mm and y=180mm and zero is into upper left corner.
Is it possible to change like EZCAD?
With x= -90 / +90 mm and y= -90 / +90 mm?

2

Yes, wondered that myself.
Following.

3

The problem of zero at upper left corner is, if I exchange my lens (I have also a 150x150mm lens), I must adapt all files to new center point. In case of origin at middle of workspace I must only resize engravement in worst case.

1 Like
4

We do not currently have a feature for this.

1 Like
5

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.