I’ve been using Lightburn with my Ortur 20w for several months. Last night, burned a few projects no issue. This morning, upgraded to v1.0.01 and ran the SAME project and twice I received an Error that stopped the project ~1/3 of the way through (Error;9, G-code Locked out during alarm or jog state.)
Im running an image (filtered thru lightburn) at 65% power, 4200mm/min, so nothing excessive there. Just going up and down on a 8x10" canvas. All plugs are tight, ground is secure, legs hold the machine in place. Again, this same project ran last night but today its failed twice.
Does v1.0.01 make any changes I need to look at?