Showing cut lines

When I cut in line mode I get the cut lines showing. Some suggested to type $32=1. When
I did that the laser went through the motions but never burned anything. Any help would be appreciated. just got my FoxAlien 4040 LE yesterday.bob:20201129_095417

do you have restart lightburn ,after setting $32=1???

hmmm, let me try that

$32=1 enables laser mode, which also enables ‘Variable Power’ mode. If it doesn’t burn with that on, it most likely means you tried to run the job faster than your laser is allowed to move. Read through the bit under the power/speed graph here: Configuring a 3018 CNC (or other CNC-based laser) for use with LightBurn

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.