My computer crashed while engraving earlier. Image had a 1 hour 15 minute time estimate. Same engraving this morning was close to that estimate. Trying to burn image this afternoon, estimate is not 1 hour 40 minutes. Laser head doesn’t change speeds when changing settings while doing test burns.
Any ideas on what setting(s) need to looked at?
If you don’t change any Lightburn settings or resize the work, that estimate remains very repeatable.
The preview estimates gets the data to compute this from
Might try Edit → Device Settings → Additional Settings
Then click on Read From Controller
This will read the machines values… it’s possible they haven’t been updated
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
