Start Program vs. Send Program

[Stroonzo (Jeff)]

Start vs Send on Wifi

“Send” just sends the file to the laser. “Start” sends it as a temporary (unnamed) file, and the laser begins running the job when “enough” data has arrived. (I’m not sure what counts as “enough” in this case - it’s up to the hardware). If you are sending a job that has photo engraving, or high-speed engraving, those can take a decent amount of CPU horsepower to execute the job, and receiving the file also requires CPU time. If the job is complex enough, it’s possible for the controller to s…

And I found this using the search as seen here:

There’s a lot of great info on the forum, so don’t forget to search.