Switch from Eazycad to LightBurn and fiberlaser problem

[Julieparis77 (Morihain)]

Hello,

I just switched to lightburn for engraving on my fiber laser (I used an export on eazycad previously) and I have two problems:

• the red laser preview (frame) does not fall at the place of the engraving (I have a mm deviation at the bottom right), problem that I don’t have with eazycad, see photo of the round

• I put the same settings as in Eazycad but don’t get the same results, the burning is less sustained for the same settings…

Any idea ?

[0Fh (Robert)]

Try this: Galvo Laser Red Dot Alignment - YouTube