As the title says, i have daja mr carve m4 and its running on the 1.07 beta ver, of lightburn but i cant find a way to use the diode laser

Tell us more, how do you switch between lasers with original software? Can the original software output some code for us to check? Are you trying both sametime ?

[image] jelthenewbie: mr carve m4 Isn’t there a button on the left side of the case for this? If you want the software to do this, maybe @Rick could advise… I don’t know if it’s supported or not. It’s the weekend, so be patient. They claim 15W at 1064nM , never seen that much power out of …

yes, the seacad(original software) has a button to switch from diode to fiber. im not trying to use the same mode at the same time i want to switch between each engrave from switching different materials like wooden keychains and or aluminum keychain.

the button doesnt work. tried using it. bought the m4 cause its a cheaper alternative compared to xtool f1 or the laserpecker, im using it for video purposes since diode laser doesnt look good on videos because of the blue light and also i want a galvo for the same reason, i own desktop diode laser …

[image] jelthenewbie: button doesnt work Then go back to the vendor for a fix… That would seem to say you have some kind of hardware issue… [image] jelthenewbie: cheaper alternative compared to xtool f1 or the laserpecker Completely understand… We (at least most of us) are limited by …

[image] jelthenewbie: yes, the seacad(original software) has a button to switch from diode to fiber. [image] jelthenewbie: the button doesnt work. Are you saying the button in SeaCad does not work, or referring to a switch in LightBurn? Update: @gilaraujo mentioned in a side chat that…

I watched a video on this and it showed them pressing a physical button on the left side of the machine to switch between lasers. :smile_cat:

LightBurn Software Forum

Switching to diode from fiber laser using daja mr. carve m4 dual laser

LightBurn Software Questions