I am trying to do test fires with my new Omtech Polar 350, but I am unable to find the enable fire button in the device settings, can someone tell me where it is or should I go back to an earlier version to enable it?
I don’t think the Polar or anything with a Ruida does. I run an older version, but it’s never been able to case it lase for anything other than a job.
With a new version, I don’t know, but I can’t see that happening.
Hang in there…
Thank you. I will stop looking 
& give Omtech support a call
If you’re trying to pulse the machine, that’s usually done via the machines control panel, if you have one.
I don’t know how to pulse it from the PC via Lightburn. As far as I know there is no software pulse on these.
Do you have the Polar plus, it has a console, without that, I don’t know what to advise.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.