I posted the Lightburn supported controller and your model is not among them. Some things in these controllers are not handled the same across all of the Topwisdom controllers.
If you have any issues, post them…
I don’t know for sure, but my guess is that depending on it’s configuration it’s either a spindle control or an air assist (Wind) control. When it’s configured for a laser it probably knows there is no spindle…
Not all of these controller run just the plain old laser stuff…
I’d guess you could probably just run a layer with air assist and check it’s output without making it a complicated issue.
Others here have Trocen controllers, so I’d think you’d hear from someone that has done this…
Ask if you need to… we are here…
Good luck
