Traversal moves included in finished project

[AndyK (Andy)]

I have just completed a small project and found that the traversal lines have also come through between each letter, frame etc.
how do I turn this off please?

3018 GRBL 1.1F

TIA
Andy

[LightBurn (Oz)]

Laser not turning off between cuts? (burning during travel moves)

If you have a GRBL device, and your laser is still on when moving between shapes, like this: [image] It most likely means you are using GRBL 1.1f or later, but do not have the controller in Laser Mode. Fix this by typing $32=1 in the Console window and pressing enter If you have a Ruida or other DSP controller and are seeing this happen, it is most likely a dying high-voltage power supply unit (PSU). The drive circuit that turns the laser power off and on tends to go first, before the part …

[AndyK (Andy)]

Thank you OZ
The only thing I did not check
Cheers