Trocen AWC708S Continuous Jog is reversed on X axis?

LightBurn Hardware Compatibility Trocen AWC controllers
1

Hello,

Can any one explain why the X axis reverses if Continuous Jog is on?

I see a few people are making topics about this in the past but I can’t find a solution for this problem.

I use the AWC708S controller and even updated the firmware to the latest one which also did not fix it.
My machine homes to the rear right, LB is set to the rear right corner in the settings, all works fine including camera and jogging with the “pinpoint” and jogging in the move window when Continuous Jog is off. Using Lightburn version 1.13.01

Thanks in advance for helping me!

Regards,
Alexander

2

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.