Trocen TL 3120 solenoid diagram

[Boza]

Hello, yesterday I purchase 2nd hand laser 1400x900 mm. Was testing whole day and everything look fine. Im wondering if someone have wiring diagram for solenoid valve for TL-3120 because laser have only stock pump and isnt that good for cutting. First time Im dealing with Trocen controller,my other 2 lasers have Ruida
Thanks in advance

[jkwilborn (Jack Wilborn)]

See if this helps…

Air Assist Clarification

Since there is conflict, I ran it down. would indicate that it’s operating as I suggested. Final truth is the actual wiring manual (or one operating), which probably trumps us all, where I should have looked in the first place… This link to the TL-3120-PLUS has this illustration… [Screenshot from 2022-03-03 09-39-49] [Screenshot from 2022-03-03 10-28-21] The wiring shows an OUT3, but I don’t see it in any of the device photos. There doesn’t seem to be any kind of current values. They …

Good luck

[MDWilson (Mark Wilson)]

I ran into the same issue. A bit confusing but for the air assist solenoid you use out 6. (at least on the Trocen 7813)