I’m new with engraving. And I have a question. Why when I’m using Lightburn when I try to engrave this the Laser try to go outside the printer and the motor is in abutment. I’m scared to break something.
I can print if I put the image in the Up Left corner.
Is it possible to set this correctly and if I put an image at the center in Lightburn, it’s at center to on the TTS-55
Sorry for my english I hope everyone will understand my problem.
Have a good day
The area of your workspace in LightBurn for some controllers (your account here, and the forum tag says grbl) isn’t always the same. You can accidentally make the workspace area larger than your actual engraving area during setup.
The documentation here may be helpful! So sorry this slipped through the cracks.
