Have been trying to use my new Two Trees laser to engrave items for my small business. Purchased a lightburn camera (120/ 5mp) and use a tripod so the camera never moves. have calibrated the camera and aligned it. however, after doing this and updating overlay so I can engrave in a specific place using the camera view, whenever I go to frame the engraving, the laser is off by a substantial amount. Any help would be appreciated
I don’t use a camera, but positioning usually means you need to check if you’re in absolute/relative coords, if the laser knows where it is, etc.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.