I’m throwing this out there on the LightBurn forum because I’m not getting anywhere on how to update my firmware on my Longer Ray5 10W laser from Longer Support. I have limit switches and a new cable to install. The firmware installation guide says Install the MKSLaserTool_setup V1.1.2.exe file - F…

I have a DCL32 board on my laser, they are not the same but I used the MKSLaserTool to update the firmware too. I hope this will help you. [MKSL1_5] [MKSL2_5] [MKSL3_5] [MKSL4_5] [MKSL5_5]

I have a MacBook - not a Windows PC. This only helps w/Windows PC…I believe.

The .exe file is meant to be run on the Windows platform, like all of these Chinese programs. Many of them will tell you they don’t support anything else. Simple because they don’t have any software that runs on anything other than a Windows machine. If you don’t have or have access to a Window…

Yes, of couse. My willingness to help missed that detail. I apologize. :flushed:

[image] Kuth: missed that detail. I apologize. :flushed: Take heart… It happens all the time. It’s a Bright-People problem. :slight_smile:

[image] JohnJohn: It’s a Bright-People problem. I must be so brigh that I blind myself to miss some details. :rofl: :rofl: Thanks John! :+1: :sunglasses:

LightBurn Software Forum

Update Firmware on Longer Ray5 10W

LightBurn Software Questions

longer-ray5

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled